1.  Multi cavity uniform crushing, high chromium plate hammer, unique lining plate, especially suitable for crushing hard rock, high efficiency and energy saving

2.  Large feed inlet, high crushing chamber, to meet the material hardness; large block degree, less powder of the products.

3.  The feed inlet is provided with a chain act to prevent the material flying out of the crusher, and the wear of the quick-wear parts is relatively small, the metal utilization rate is high, and the service life will be longer

4.  The entire plate structure of the finished material is of small size and cubic, no grain

5.  Fully hydraulic open, easy to repair and replace wearing parts

6.  Because the impact strength of the material is more than ten times less than the compressive strength, so the crushing efficiency is high, the energy consumption is low, generally 0.5 ~ 1.3kW H / T

7.  Crushing ratio is large, generally in 40 to 150. Thus, it can reduce the number of crushing segments, simplify the production process, save investment and reduce production cost.

8.  The equipment is simple in structure, easy to manufacture, and operate and maintenance. The equipment has the advantages of light weight, whitout obvious unbalance vibration and heavy equipment foundation when it works.

9.  It has the characteristics of selective crushing, that is, it the density of the material is small, the particle size is large; if the density of the material is large, the particle size is small, which is good fo the mineral separation.

10.  The counter plate angle can be adjusted, to ensure that the material between the back plate and the rotor was repeatedly impact the right angle, effectively improve the crushing efficiency, reduce the energy consumption in the process of crushing

11.  The design of the plate hammer meet the reliable work, easy handling and improve the utilization rate of metals, usually made of high chromium cast iron, high manganese steel and other wear-resistant alloy steel, durable

12.  Clamping block automatic clamping mechanism driven by a cylinder, connecting rod and linear guide rail, the pressing block clamping, clamping, the other end of the feed, at the same time, release the return sequence.The whole process uses the pneumatic to control, accurate and reliable, satisfy the requirements

The Production cycle of Shunda Impact Crusher is about 60 days, but it is only for reference. Due to the impact of climate, the supply and demand of raw materials and other factors, there will be little changes in the specific production cycle, the details please get in touch with Shunda staff and subjected to the contract.